ZIXU teach you how to maintain and maintain pneumatic marking machine, so that your marking machine life of up to ten years
Here are a few steps marking machine you do it
We ZIXU to provide more conservation work. These jobs will make your life longer.
1, X, Y axis sliding rod should be kept clean, with ash or iron is not allowed to stay on top, so as not to affect the accuracy of rail;
2, regularly check the X, Y axis with the fastening block is loose (three months);
3, X, Y axis sliding rod a weekly and 20# above the oil a little, and hold a header along X and Y direction moving back and forth several times;
4, keep a header cylinder clean, do not allow dust and scraps into gas or steel, combined with lubricating oil (day before oiling from the exhaust hole);
There are oil and iron does not allow 5, switch on;
6, regular check X, Y axis motor and synchronous belt wheel connection sleep is loose, every three months check once;
7, Mo loss may repair the needle, needle is removed to the left, the needle sleeve, remove the rubber sealing ring can be removed and a reset spring needle;
8, when the air source is connected, the two pieces of automatic drainage, at this time there will be a gas discharge, after a few minutes to return to normal, six months to check whether the air is a normal two pieces;
9, regularly check the X, Y axis of the tension of the belt (three months);
10, compressed air should meet the technical requirements of the indicators.
Do the above work, your machine will be able to run well, the life of the marking machine extended to the longest.
Marking machine daily maintenance is essential.
Welcome to visit the official website: www.cnmarking.com