ZIXU News

The installation and application of the software system of pneumatic marking machine

Author: zixu   Time: 2017/03/10

The installation and application of the software system of pneumatic marking machine
welcome to enter our office web   www.laser1688.com
                                                     www.cnmarking.com
(1) reduction is not normal
Fault: control panel is bad; the limit switch wiring off or bad; bad contact control cable
Troubleshooting: check the line or replacement; replacement; check
(2) editor mark completed
Fault: mark WINDOWSXP version of the marking and Chinese conflict input method
Troubleshooting: after the completion of the editing, while holding down the CTRL+ key to switch the input method to the English state and then start marking.  
(3) after the boot of the computer error messages, restart the same reason for failure: the relevant documents were deleted, resulting in the operation of the system damage Troubleshooting: reinstall the operating system
(4) marking needle walking is not smooth, intermittent fault: the guide rail is not smooth; computer communication is not good; the computer system does not meet the requirements, whether there are other operating software running Troubleshooting: Lubrication guide; even a computer data line; check the computer operating system and operation.
The software of the pneumatic marking machine can be updated and upgraded.
We will use more language for operation.
Zixu Machinery content manager system | Zixu CMS
 
  • Tel
  • Mail
  • Top
  • Address
  • Inquiry
iccidojsjcjcg +86-18302387976