ZIXU News

Pneumatic marking machine is broken, pneumatic marking machine does not work what is the reason

Author: zixu   Time: 2017/02/27

Pneumatic marking machine is broken, pneumatic marking machine does not work what is the reason
More Advisory visit official website: www.laser1688.com
Www.cnmarking.com
Failure reason: the display card is bad or not good contact with the motherboard; the display is bad; the signal line is not plugged in.
Troubleshooting: re insert or replace; professional maintenance
(2) communication error
Failure reason: bad control board; parallel port mode or card address is not appropriate; communication cable contact is not good or some disconnection;
To replace or repair; reset; re insert, replace, or check
(3) the power supply lamp of marking machine is not bright
Failure reason: power fuse broken; power switch contact is not good.
Troubleshooting: replace the fuse
(4) when the switch indicator light is not bright
Fault: proximity switches proximity switches damaged serious contamination;
Troubleshooting: Sassafras net surface replacement;
ZIXU for you to solve the problem, our engineering department will provide you with maintenance and repair services.
Zixu Machinery content manager system | Zixu CMS
 
  • Tel
  • Mail
  • Top
  • Address
  • Inquiry
iccidojsjcjcg +86-18302387976