Marking needle does not move. The direction of X axis and Y axis common problems
Welcome to the official website: www.cnmarking.com
There are many reasons why the needle of the marking machine does not move.
(1) X or Y direction of real
Failure reason: control board or contact is not good; X or Y direction signal line contact is not good; X or Y direction drive plate bad; control board part of the fault. The X or Y direction motor is bad; the drive cable is not in contact with or has the broken line 19 core cable to insert the contact is not good or has the broken line; the gear or the belt is loose.
Troubleshooting: replacement or repair; inspection and maintenance; replacement; replacement; check signal cable; cable on-off check; check the adjustment or re fixation;
(2) the computer boot into the marking system, X, Y axis motor can be locked, but start marking X, Y axis had no reaction
Fault: check the computer parallel port and marking the 19 core circuit board is connected to the data line in the machine is connected
Troubleshooting: turn off the power of the marking machine, exit the marking system, check and confirm the contact well.
(3) X, Y axis motor can be locked, but after the start of marking the X axis or Y axis in situ jitter, can not be labeled according to normal editing
Fault: check mark pin X or Y direction is beyond the scope of marking
Troubleshooting: turn off the power supply marking machine, the center position of the manual to tag pin X, Y direction, to re start the marking machine system will automatically correct
(4) the printing process is normal, X or Y axis does not return to zero, each print is completed to the end of the mark to continue to mark
Although the size of the marking machine is small, but contains a lot of accessories, we need to check the machine one by one to solve the problem of machine needle does not move.
Welcome to ZIXU official website for more information.