ZIXU News

Marking error of dot peen pneumatic marking machine

Author: zixu   Time: 2017/02/28

Marking error of dot peen pneumatic marking machine
welcome to our web for more information: www.laser1688.com
                                                                   www.cnmarking.com
(5) marking needle uninterrupted impact or shock amplitude is small
Fault: gas flow rate is insufficient; the gas source switch open enough; the spring in the marking needle is blocked; compressed air pressure low (0.3 - 0.7Mpa)
Troubleshooting: replacement of the trachea; open; check; adjust or replace the spring pressure drop; note - point lubricating oil
(6) marking needle impact of flat rate decreased
Fault: print needle spring fatigue; marking needle of a foreign body;
Troubleshooting: replacement of cleaning;
(7) in the process of printing, marking needle trajectory, back to zero after the shell hit
Fault: X or Y axis close to switch loose or burn
Troubleshooting: check the proximity switch position or replace the proximity switch
Zixu Machinery content manager system | Zixu CMS
 
  • Tel
  • Mail
  • Top
  • Address
  • Inquiry
iccidojsjcjcg +86-18323847792