ZIXU News

How to solve the problem of the marking machine, especially the marking pins

Author: zixu   Time: 2017/04/26

 

 

How to solve the problem of the marking machine, especially the marking pins
The fault of the pneumatic marking machine. Have you encountered any problems when using the marking machine, do you know how to solve it?
Our factory will provide solutions, we believe that the need for higher configuration and processing accuracy to ensure that the failure rate of marking machine is low.
Hit the needle or out of the needle is not normal:
The check valve pressure is normal (normal value 2 - 4 ATM);
The check gas path is connected, whether there is a leak needle sleeve connection, pipe connector is plugged in;
The use of manual testing to see whether the steel vibration, vibration is normal to see empty needle;
Check the circuit board, frequency solenoid valve and the duty ratio of the potentiometer is adjusted to normal. W1 frequency modulation, W2 modulation duty cycle, after adjusting the control board in the upper right corner of the Department, 24- and MAC voltage is less than 9.6V.
Purple Xu provides a variety of marking program, custom marking machine, including electric marking machine, pneumatic marking machine, wholesale marking needle, high quality laser marking machine
 
Welcome to our website: www.cnmarking.com
Www.cnmarkermachine.com

Zixu Machinery content manager system | Zixu CMS

  • Tel
  • Mail
  • Top
  • Address
  • Inquiry
iccidojsjcjcg +86-18302387976