ZIXU News

How to control the width of the pneumatic marking machine head strokes

Author: zixu   Time: 2017/09/21

How to control the width of the pneumatic marking machine head strokes
How is the width of the stroke drawn during the marking of the pneumatic marking machine? Usually through the replacement of the needle model to achieve, can also be achieved through the depth. The larger the diameter of the needle, the wider the stroke is, the wider the marker is.
 
Chongqing Zixu factory pneumatic marking machine needle generally have two kinds of specifications Model: diameter 3 mm and diameter 5 mm (referred to as: model φ3 and φ5). Length uniformity of 65 mm, the top diameter of 10 mm.

marking pin

Where the diameter refers to the middle of the needle rod diameter, the lower end of the tip is generally made into 60 degrees or 45 degrees, then the greater the diameter of the needle rod, the location of the job area is also greater, marked the stroke will certainly be wider , And vice versa.

 
Pneumatic marking machine, marking machine, marking head
  • Tel
  • Mail
  • Top
  • Address
  • Inquiry
iccidojsjcjcg +86-18323847792