Dot peen marking machine marking the wrong font, not pretty, how to solve
Author: zixu Time: 2017/03/02
Dot peen marking machine marking the wrong font, not pretty, how to solve
welcome to visiting our office web: www.laser1688.com
www.cnmarking.com
Marking character problem
(1) marking character tailing phenomenon
Fault: solenoid valve within the foreign body; off gas delay parameters; control program is destroyed;
Troubleshooting: cleaning; resetting (increasing); reinstalling.
(2) the character of irregular appearance.
Failure reason: marking needle wear serious, clearance is too large; X or Y direction transmission belt loose; part of the head part of the serious wear control board failure. Cause excessive clearance.
Troubleshooting: replace the marking needle; adjust the tightness of the belt; adjust the repair or replacement.
(3) marking font character deformation, the lower half part of the wrong line, on a
Fault: loose belt or Y axis, the drive electrode damage; marking requirements does not comply with the current software version
